Prevent Cell Damage:
NEVER insert anything into the cell or pressure wash it. This
will damage the electrodes.
1. Turn off the power to the spa. Open the spa cover and remove the filter lid.
2. Unscrew gray filter cap and gently pull the cell out of the filter.
3. Inspect the cell for scale by looking between the electrodes.
4. Unscrew the lid to the cleaning bottle included with the ACE® system and fill with
spa water to the fill-line indicated on the bottle. Add 3 tablespoons of pH down to
the cleaning bottle and secure lid. Shake bottle to create cleaning solution.
NOTE:
A stronger cleaning solution of 1 pt muriatic pool acid & 10 pt water can be used
as well as a commercial cell cleaner - follow directions on bottle.
5. Remove the lid from the cleaning bottle. Place the cell in the bottle,
ensuring that the bottom of cell is floating.
6. Soak the cell for 10 minutes or until bubbles stop coming from the cell. If bubbles
are still releasing from the cell after 10 minutes, continue soaking until the cell is
clean and all scale is removed.
7. Rinse cell and inspect for cleaning completion.
8. Replace cell into the filter standpipe. Screw on the gray filter cap, replace the
filter lid, and power up the spa. Ensure that the cell is at the bottom of the filter
standpipe by feeling for the pull of the pump’s suction.
Troubleshooting
Treating for Metals:
High Metal content can cause staining and discolored water. It’s important that met-
als are removed before starting up the ACE system.
1. Fill the spa with the Clean Screen
®
pre-filter, ensuring that the valve is only 50%
open (45° angle).
2. Ensure that there is no ozone unit installed and that the ACE system is turned off
(Output level 0).
3. Add FreshWater Stain & Scale metal control according to the instructions on the
bottle.
4. Place a Vanishing Act Calcium remover over the low speed jet suction.
5. DO NOT add oxidizers (chlorine, ozone, ACE) for at least 24 hours.
Flashing On/Ready light and Water Care Icon
The green ON indicator light, in the Hot Spring logo on the front of your spa will
slowly flash when the ACE system requires attention. The water care icon on the
main control panel will also flash as an indication that some action is needed. Access
the ACE system menu by pressing the
MODE ▲
button several times from the home
screen to reach the ACE menu. Press the
ON ▲
button to enter the ACE system
menu and review systme status messages.
ACE Salt Water Sanitizing System
Page 9
Содержание LIMELIGHT COLLECTION Ace
Страница 1: ...L I M E L I G H T C O L L E C T I O N A C E O W N E R S M A N U A L...
Страница 18: ......
Страница 19: ......