7 of 37
Indesit
Company
Service Manual UK
English
APPLIANCE DIMENSIONS
(all measurements are approximate)
WATER FILTER
1.
Locate the water filter cartridge cap below the freezer compartment door.
Rotate the cap counter clockwise to a vertical position and pull the cap and filter cartridge out
through the base grille.
Note:
Since there is water in the cartridge, some spilling may occur.
2.
Remove the cartridge cap by sliding it off the end of the old cartridge.
DO NOT DISCARD THE CAP.
3.
Take the new cartridge out of its packaging and remove the protective cover from the o-rings.
Make a note of the installation date in the space provided on the new cartridge.
4.
Slide the cartridge cap onto the new cartridge.
5.
With the cartridge cap in the vertical position, push the new filter cartridge into the base grille until
it stops. Rotate the cartridge cap clockwise to a horizontal position.
6.
RUN WATER THROUGH THE DISPENSER UNTIL THE WATER RUNS CLEAR (about 9-14 litres
or 6-7 minutes). This will clean the system and clear air from the lines.
Note:
As air is cleared from
the system, water may spurt out of the dispenser.
APERTURE MEASUREMENTS
PLAN VIEW
(WITH DOORS OPEN 90° AND FULLY)
Cabinet Height = 1760 mm
Cabinet Height with doors = 1765 mm
Depth including door handles: 605 mm + 150 mm = 750 mm
Depth without doors = 605 mm
Depth without handles: 605 mm + 110 mm = 715 mm
