Hotpoint Ariston SXBHAE 920, Инструкция по эксплуатации, Страница: 26 / 213

26
DOOR HEIGHT ADJUSTMENT
If the doors of the appliance are not aligned then the height of them can be adjusted, if required
please follow the below steps.
Note: The maximum height adjustment is 5mm
Rotate the locking nut clockwise (as shown in the diagram below) with a wrench for 2 full rotations
to loosen it. You can now rotate the adjusting nut(as shown in diagram below) to raise or lower the
height of the door. Once the door is set to your desired position, then tighten the locking nut by
rotating it anti-clockwise.
When the fridge door is low:
Open the door, use a wrench to rotate the
adjusting nut anti-clockwise to raise the height
of the door. Once the doors are aligned, then
tighten the locking nut by rotating it clockwise.
When the fridge door is high:
Open the door, use a wrench to rotate the
adjusting nut clockwise to lower the height of
the door.
Once the doors are aligned, then tighten the
locking nutby rotating it clockwise.
ELECTRICAL CONNECTION FOR GREAT
BRITAIN AND IRELAND ONLY
Warning - this appliance must be earthed
Fuse replacement
If the mains lead of this appliance is fitted with a BS 1363A 13amp
fused plug, to change a fuse in this type of plug use an A.S.T.A.
approved fuse to BS 1362 type and proceed as follows:
1. Remove the fuse cover (A) and fuse (B).
2. Fit replacement 13A fuse into fuse cover.
3. Refit both into plug.
Important:
The fuse cover must be refitted when changing a fuse and if the fuse cover is lost the plug must not
be used until a correct replacement is fitted.
Correct replacement are identified by the colour insert or the colour embossed in words on the base
of the plug. Replacement fuse covers are available from your local electrical store.
For the Republic of Ireland only
The information given in respect of Great Britain will frequently apply, but a third type of plug and
socket is also used, the 2-pin, side earth type.
Socket outlet / plug (valid for both countries)
If the fitted plug is not suitable for your socket outlet, please contact After-sales Service for further
instruction. Please do not attempt to change plug yourself. This procedure needs to be carried out
by a qualified technician in compliance with the manufactures instructions and current standard safety
regulations.