Hotpoint Ariston CISHB 10 A.1, Руководство по эксплуатации

Страница: 3 / 24

3
GB
E lectrical connections
The cooker must be connected to the mains
electricity supply. It is designed to operate with
alternating current at the voltage and frequency
indicated on the data plate ( see the following page ).
The hob is connected to the cooker using a special
connector.
BUILT-IN HOB
BUILT-IN COOKER
WHITE RED YELLOW BLUE GREEN
Only on
certain models
F ittin g t h e p o w er s upp l y ca b le
1. Open the terminal
board by inserting a
screwdriver into the
side tabs of the cover.
Use the screwdriver as
a lever by pushing it
down to open the cover
( see diagram ).
2. Install the power supply cable by loosening the
cable clamp screw and the wire contact screws L-N-
. Connect the wires to the corresponding
terminals: the Blue wire to the terminal marked (N),
the Brown wire to the terminal marked (L) and the
Yellow Green wire to the terminal marked .
Replace the metal protection after performing all the
necessary hob connections. If the hob is removed
from its position, the red cap which was originally
protecting the red connector must be replaced.
The terminal board is designed for a 400 V three-
phase connection ( see diagrams below ).
400V 3N~H05RR-F
5x2.5 CEI-UNEL 35363
If the electrical system has other characteristics ( see
diagrams below ), carry out the electrical connection
using the connection supports provided in the box
P.
230V 1N~H07RN-F 3x4
CEI-UNEL 35364
400V 2N~H05RR-F
4x2.5 CEI-UNEL 35363
3. Secure the power supply cable by fastening the
clamp screw.
4. Close the cover of the terminal board.
N L3 L1 L2
1 3
2 4
5
N
L2
L3
L1
P
N L
1 3
2 4
5
N L2 L1
1 3
2 4
5