10
9. Apply a film of grease to the barrel of an M8 x
55mm Bolt Set (92) and to a 7mm Spacer (55).
Slide an M8 Washer (69) and the Spacer onto
the barrel.
While another person holds the front end of the
Left Pedal Leg (14) inside of the bracket on the
left Upper Body Leg (17), insert the barrel of the
M8 x 55mm Bolt Set (92) through both parts.
Next, slide a 7mm Spacer (55) and an M8
Washer (69) onto the end of the barrel of the
Bolt Set. Then, turn the screw of the Bolt Set a
few turns into the barrel.
Do not overtighten
the Bolt Set; the left Upper Body Leg must be
able to pivot freely.
Attach the right Upper Body Leg (not shown)
to the Right Pedal Leg (not shown) in the
same way.
See step 7.
Tighten the four M8 x 38mm Button
Bolts (58).
10. While another person holds the Display Console
(74) and the Control Console (75) near the
Upright (2), connect the Pulse Jumper Wire (76)
to the console pulse wire, and the Upper Wire
Harness (77) to the console wire harness. Insert
the excess wires into the Upright.
Tip: Avoid pinching the wires.
Set the
Consoles (74, 75) on the Upright (2). Attach the
Consoles with six M4 x 16mm Screws (47).
14
9
10
2
92
17
92
55
55
69
69
47
47
77
76
75
74
Grease
Avoid pinching
the wires
All manuals and user guides at all-guides.com
