7.
Make sure that all parts are properly tightened before you use the treadmill.
Keep the included hex keys
for adjustment purposes. To protect the floor or carpet from damage, place a mat under the treadmill.
6. After the treadmill is moved to the location where it will
be used (see HOW TO MOVE THE TREADMILL on
page 19), make sure that both Rear Feet (5) and both
Wheels (not shown) rest firmly on your floor. If the
treadmill rocks slightly on your floor, loosen the 3/4"
Jam Nut (113) above the right Rear Foot. Turn the right
Rear Foot clockwise or counterclockwise until the rock-
ing motion is eliminated. Then, retighten the Jam Nut.
5. Plug the indicated end of the Power Cord (48) fully into
the treadmill as shown.
4.
Be careful to avoid pinching your hands or the Wire
Harnesses (not shown) during this step.
While a second person holds the Uprights (95, 97), re-
move the two 1/2" x 1" Bolts (96) used in step 1. Next,
slide the Uprights fully onto the brackets on the Frame
(not shown). Attach each Upright with four 1/2" x 1"
Bolts (96) as shown.
Firmly tighten all eight 1/2" x 1"
Bolts.
Firmly tighten the eight 3/8" x 3/4" Bolts (99).
7
99
99
99
95
96
96
97
4
3. Connect the Upright Wire Harness (100) to the Power
Wire Harness (57).
See the inset drawing. The con-
nectors should slide together easily and snap into
place.
If they do not, turn one connector and try again.
IF THE CONNECTORS ARE NOT INSERTED PROP-
ERLY, THE CONSOLE MAY BE DAMAGED WHEN
THE POWER IS TURNED ON.
Next, insert the connectors down into the hole in the
Frame (76), and push all the excess wire harness up
into the Right Upright (95).
Make sure that the Wire
Harnesses remain fully connected.
3
95
76
48
5
5
113
6
5
113
100
57
