6
Assembly requires two persons.
Set the treadmill in a cleared area and remove all packing materials.
Do not
dispose of the packing materials until assembly is completed. Assembly requires only the included hex
keys.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is
the key number of the part, from the PART LIST near the end of this manual. The number after the parentheses
is the quantity needed for assembly.
Note: If a part is not in the hardware kit, check to see if it is preattached
to one of the parts to be assembled. Extra hardware may be included.
2. Have a second person hold the Handrail (91) near the
Uprights (95, 97). Feed the Upright Wire Harness (100)
in the Handrail downward into the Right Upright, and pull
the end of the Upright Wire Harness out of the lower end
of the Right Upright. If there is a wire tie on the end of
the Upright Wire Harness, remove it. Then, set the
Handrail on the Uprights.
Partially tighten eight 3/8" x 3/4" Bolts (99) into the
Uprights (95, 97) and the Handrail (91).
Do not fully
tighten the Bolts yet. Be careful to avoid pinching
the Upright Wire Harness (100).
Note: The Water Bottle Holder (85) and the Accessory
Tray (86) are replaceable. If these parts become dis-
lodged, simply press them back into place.
1. Slide the Right and Left Uprights (95, 97) onto the brack-
ets near the front of the Frame (76).
Make sure that the
Uprights are on the correct sides; the indicated
holes must face inward.
Raise the Right Upright (95) until the lower hole in the
front of the Right Upright is aligned with the upper hole
in the bracket. Partially tighten a 1/2" x 1" Bolt (96) into
the Right Upright and the bracket.
Do not fully tighten
the Bolt yet.
The Right Upright will rest on the Bolt.
Repeat this step with the Left Upright (97).
ASSEMBLY
1/2" x 1" Bolt (96)–8
3/8" x 3/4" Bolt (99)–8
95
96
76
97
Holes
1
96
97
91
86
88
85
99
99
99
100
2
95
