Hoshizaki MODwater DWM-20A, Инструкция по эксплуатации

Страница: 21 / 45

21
start beeping loudly. However, thanks to the paper towel wrapped around, a small spill from a glass of water or
from the drain pan would not be sufficient to trigger the leak detector.
•
Carefully position the leak detector under the counter, close to the double All-in-One filters, or in an area where
potential flooded water would naturally accumulate, (see diagram below).
• Now the installation is complete, and it is time for setup and fine tuning. Place a bottle or container on the drain
pan. Dispense alkaline water (white button) until the dispensed water is clear of carbon particles. NOTE: It is
normal that the first two gallon of mineralized alkaline water appears black or milky in color. Wait 10 minutes.
Dispense two gallons more until the water is completely clear. Repeat the process after waiting another 10
minutes until the alkaline water is totally transparent.
•
Dispense 16 oz. of chilled (still) water (blue button). If the DWM-20A has been turned on for more than one hour,
the chilled water now should be ice-cold.
•
Next, dispense 16 oz. of sparkling water (green button). Make sure the regulator has the arrow in the green
region (see fig 6 on page 18). For fine tuning of the carbonation level, refer to the table on page 29.
• Next, dispense hot water (red button). Check if the red LED light top left is on. If the hot water tank heater has
been on for more than 10 minutes, the hot water now should be boiling-hot.
BACK VIEW