15
•
IMPORTANT:
connect the drain pan. The drain pan comes connected to a drain pipe that runs underneath the
dispenser and can be connected to a drain by a flexible plastic tube connected to the back of the DWM-20A
dispenser. If there is not enough downward slope for the drain line, please install an accessory drain pump to
ensure water does not back-up in the drain line. Remove the two (2) black rubber plugs at the bottom of the
drain pan and at the end of the drain tube.
•
Alternatively, if the location where the dispenser is installed has no drain, you can go “drainless” and use the
drain pan as a “drip tray.” You must detach the metal pipe underneath the drain pan (by pushing down the silicon
connector) and leave the plug at the bottom of the drain pan. The drain pan must be emptied periodically, or
when it is full. NOTE: Please be sure not to pour non-water liquids in the drain pan as they can create unsanitary
conditions.
•
The DWM-20A drain pan can be connected to a drain through a flexible plastic tube (1/2”) as per picture (not
included).
From drain pan
Drain to the floor
BACK VIEW
Содержание MODwater DWM-20A
Страница 1: ...1...
Страница 26: ...26 BACK BACK CORNER Completed Installation of DWM 20A on AM 50 C 80 Water Source Water Source...
Страница 27: ...27 MAX 20 lbs MAX TILT 15 DEGREES 15 MAX WARNING MAX LOAD WEIGHT ON TOP OF DWM 20A 20 LBS WARNING DO NOT TILT...
Страница 36: ...36 Open the Side Panel Door Replace the alkaline chamber HS 5442...