45
10) Turn on the power supply, and start the washing process.
11) Turn off the power supply after 30 minutes.
12) Remove the front panel and the insulation panel.
13) Drain the water tank. (See step 5 above).
14) Replace the cap and the insulation panel in their correct positions.
15) Move the control switch to the “ICE” position.
16) Close the cleaning valve.
Note: The icemaker will not operate unless the cleaning valve is completely closed.
17) Replace the front panel in its correct position.
18) Turn on the power supply to fill the water tank with water.
19) Turn off the power supply after 3 minutes.
20) Remove the front panel.
21) Move the control switch to the “WASH” position.
22) Replace the front panel in its correct position.
23) Turn on the power supply to rinse off the cleaning solution.
24) Turn off the power supply after 5 minutes.
25) Remove the front panel and insulation panel.
26) Drain the water tank by removing the cap located on the front bottom part of the ice
dropping hole. See Fig. 4.
27) After the tank has drained, replace the removed parts in their correct positions.
Note: Do not replace the insulation panel when you proceed to “2. Sanitizing
Procedure.”
28) Repeat the above steps 15) through 27) three more times to rinse thoroughly.
Note: If you do not sanitize the icemaker, go to step 9) in “2. Sanitizing Procedure.”
