18
13) Replace the spout and shroud in their correct positions.
14) Plug the unit back in. Move the power switch to the "ON" position.
15) Allow the unit to make ice using the solution. When ice stops coming out, move the
power switch to the "OFF" position and unplug the unit from the electrical outlet.
16) Remove the shroud and spout.
17) Remove the drain cap to drain any remaining solution.
18) After all of the solution has drained, replace the drain cap in its correct position.
19) Remove the reservoir cover. Using a clean container, pour water into the reservoir
until it starts to overflow into the drain pan. Replace the reservoir cover in its correct
position.
0) Remove the drain cap to drain the water.
Note: If you do not sanitize the icemaker, go to step 14 in "5. Sanitizing
Procedure - Final."
1) After the water has drained, replace the drain cap in its correct position.
3. Sanitizing Solution
IMPORTANT
For safety and maximum effectiveness, use the solution immediately after
dilution.
Dilute 1.5 fl. oz. (37 ml or .5 tbs) of a 5.5% sodium hypochlorite solution (chlorine
bleach) with .5 gallons (9.5 l) of warm water. This is a minimum amount. Make more
solution if necessary.
Using a chlorine test strip or other method, confirm that you have a concentration of
about 00 ppm.
4. Sanitizing Procedure - Initial
1) Remove the reservoir cover. Pour the sanitizing solution into the reservoir until the
solution starts to overflow into the drain pan. Replace the reservoir cover in its correct
position.
) Remove the packing and ring.
3) Pour some of the sanitizing solution into a separate, clean container. Use this sanitizing
solution and a clean cloth to wipe down the slope, scoop, scoop holder, shroud, spout,
packing, ring, door gasket, and door liner.
4) Rinse the parts thoroughly with clean water.
5) Replace the ring, packing, spout, and shroud in their correct positions.
6) Make sure at least 10 minutes have elapsed since you poured the sanitizing solution
into the reservoir, then plug the unit back in. Move the power switch to the "ON"
position.
7) Allow the unit to make ice using the solution. When ice stops coming out, move the
power switch to the "OFF" position and unplug the unit from the electrical outlet.
