5.
Machines with slewing undercarriage:
Extend the undercarriage or swivel it down
and set the switch-over ball valve
field/road
to
road
.
6.
Lift the machine completely and fill the cen
-
tre lift-out cylinders on the undercarriage
and, on machines with swinging drawbar
hitching, also the piston rod of the drawbar
cylinder with clips and lower the machine
onto the clips.
Insert enough clips to achieve sufficient
ground clearance, but at the same time
ensure that the maximum permissible
transport height is not exceeded. Follow
the section
Setting the transport height
to this
end.
7. Retract the DiscSystem using the control
unit.
Parking
Initial position: The machine is folded in and
connected to the tractor.
1. Lift the machine completely.
2.
Machines with swinging drawbar hitching:
Fill the piston rod of the drawbar cylinder
with aluminium clips.
3. Unfold the support.
4.
Machines with swinging drawbar hitching:
Remove the aluminium clips again from the
drawbar cylinder.
WARNING
Danger of severe injury caused by the dropping/
falling drawbar.
¾
Instruct persons to leave the danger zone.
¾
Never stand under the drawbar.
5. Lower the machine to the support.
6. Engage the parking brake of the machine.
7. Loosen the connection.
Machines with swinging drawbar hitching:
Slightly lift the drawbar and close the lock
valve on the drawbar.
8. Disconnect the lines for brake, hydraulics
and lighting.
9. Move the tractor away from the machine.
48
