Hornet 727T, Руководство по установке

Страница: 37 / 43

© 2005 directed electronics, inc.
35
1-6 AUXILIARY/DELAYED ACCESSORY OUTPUT: These settings change Red/white
auxiliary output operation.
• Auxiliary output (default): in this setting if the system sees the vehicle doors lock
2 times rapidly the red/wht auxiliary channel will activate for 800mS. This is
useful for adding trunk release option.
• Delay accessory output: In this setting the red/wht auxiliary channel will turn
on a few seconds after the ignition is turned on and remain on until a door is
opened/closed, the system is armed or 1 hour lapses.
1-7 DELAYED/INSTANT DOOR TRIGGER: These setting control the siren output
when the system is set off by the door trigger input.
• Delay ON (default) in this setting if the door is opened while the system is
armed the siren will chirp 10 times prior to the constant siren output. This is still
an instant trigger and closing the door quickly will not stop the trigger sequence.
• Delay Off: in this setting if the door is opened while the system is armed the
siren will emit a constant siren output immediately
1-8 SENSOR SHUNT ZONES 1, 2 AND 4/ALL ZONES: These settings define which
zones are bypassed when opening the trunk while the system is armed.
• Sensor zones 1, 2 & 4 (default): in this setting zones 1, 2 & 4 are shunted
when the H2/5 gray wire sees a +12V input moments before H1/6 blue sees a
ground input.
• All zones: in this setting ALL zones are shunted when the H2/5 gray wire sees
a +12V input moments before H1/6 blue sees a ground input. ALL zones will be
bypassed until 5 seconds after the ground ceases on the blue wire.
1-9 SIREN DURATION 30/60 SECONDS: These settings change the siren output
from 30 seconds to 60 seconds duration when in the panic mode and when the
system is fully triggered. The siren duration can also be programmed from 1-180
seconds in 1 second increments using the Bitwriter
®
.
1-10 VALET
®
PULSE COUNT 1-5 PULSES: These settings change the number of times
the valet switch must be pressed to disarm the system without a transmitter.
• 1 pulse (default): setting is 1 pulse.
• 2-5 pulses: these settings will make it more difficult for a thief to defeat the
system.