CHAPTER 3: CONFIGURATION 01 SEPTEMBER 1998 PAGE 18
HE500OCS050/051 User Manual
CHAPTER 3: CONFIGURATION
3.1 General
The OCS can be easily configured. The following sections describe the parameters and procedures used
to configure the OCS. The sections describe the on-board configuration of the unit.
3.2
Entering the Configuration Menu
1.
To enter the configuration menu, press the key and the key at the same time.
2.
The Configuration Mode looks like the following:
3.
Pressing the
Enter
key selects the option that the indicator arrow is pointed to. Pressing or
allows the user to scroll up or down through the menu options as described in Section 3.3.
3.3
Menu Options
There are eight different menu options: The options include (a) View OCS Info (b) View Registers, (c)
View I/O Slots, (d) View Char Set, (e) Set Fkeys Mode, (f) Set RS232 Mode (g) Set Network ID and
(h) Set Contrast.
a.
View OCS Info
OCS Information Screen
What the screen display looks like
θ
The OCS Info screen shows information about the internal state of the unit. Pressing and scrolls
through the different items. Pressing
Esc
will return to the Main Menu.
Parameter
Description
Firmware
Shows the execution engine firmware version.
OCS Mode
Shows the scanning mode (Idle, DO/IO, and Run).
%I Filter
Shows the number of scans a physical input must be stable before its state is
accepted. A zero shows filtering is turned off.
Net Update
Shows the 100's of milliseconds before the network data is broadcast. This
broadcast is in additional to change of state broadcast. A zero shows this feature
is disabled.
Mem Used
Shows the number of bytes used by the ladder program.
Scan-Rate
Shows the number of milliseconds for the scan before this screen was displayed.
Self-Test
Shows if the power-up self-test passed or failed.
Fault Code
Shows the 8-bit fault code number in hexadecimal. (See Table 3.1.) If more than
one fault is detected, the displayed code will be the hexadecimal sum of the
Î
Network ID
Set Contrast
OCS Mode: Run
Scan-rate: 0.0
………………………………………………………………………………………………………………………………………………………………………………………………………………………..
Mem Used: 370
Firmware: 1.5
Self-Test: OK
Fault Code: 0
%I Filter: 0
Net Update: 0
Represents bottom
of screen
