PAGE 25 12-5-97 CHAPTER 4: CONFIGURATION
CHAPTER 4: CONFIGURATION
4.1 Setting the Drive Option Parameters
1.
After powering up the drive, the drive's LCD display should display the following:
This display indicates that the drive is in STOP mode, and that the PRG key must be pressed in order to
set the drive data.
2.
Press the PRG key. The display now shows the start of the list of the normal drive parameters as
follows:
3.
The option parameters are at the bottom of the list, and cannot be seen until the cursor keys are
pressed multiple times to display them. After pressing the UP or DOWN cursor keys repeatedly, the
option card parameters are finally displayed as follows (note that holding the cursor keys down
continuously causes the display to scroll quickly):
4.
In order to set P00, use the cursor keys (UP and/or DOWN) to highlight P00 (the highlight is
represented below with the underlined text).
STOP
PRG > DATA SET
>> > LED SEL
00 FREQ COMND
01 OPR METHOD
02 MAX Hz
03 BASE Hz-1
P00 OPTION 0
P01 OPTION 1
P02 OPTION 2
P03 OPTION 3
P00 OPTION 0
P01 OPTION 1
P02 OPTION 2
P03 OPTION 3
