6
How to Program Your
Key Code
A single user-defined 4 to 6 digit code can
be programmed into the RAPiD
®
Safe.
1. Open the RAPiD Safe with either the key
or a previously programmed RFID tag or
key code. The safe ships with a default
code and should be reprogrammed
before first use.
2. Locate the red program button to begin
programming your key code. The first
available tag location will begin to blink
to indicate program mode.
3. With the safe open, enter a 4- to 6-digit
code into the keypad. Press the “H”
after entering your code. Verify your
code is correct by re-entering your
code and pressing “H.” The motor
should cycle.
Program Button
How to Remove All RFID Tags From Safe
1. Open the RAPiD
®
Safe with either
the key or a previously programmed
RFID tag or key code. Locate the red
program button. Press and hold the
button for five seconds to erase all
tags from the safe. All five red LEDs
will begin to blink in sequence. (The
safe does not allow individual tags to
be removed. They must all be erased at
one time. The intended RFID tags can
then be reprogrammed back into the
safe with the instructions above.)
NOTE:
To abort the erase procedure,
press the “H” button on the keypad, or
do not touch anything, and the erase
procedure will automatically abort
after 10 seconds and return to normal
operation.
Test RFID tags and the key
code to confirm they are operational.
2. To confirm erasing procedure, press
and release the program button again.
All five LED lights will blink three times
to visually confirm all RFID tags have
been removed. All RFID tags will no
longer work until they are programmed
back into the safe with the instructions
in the “How to Program Your RFID
Tags” section.
Closing the Safe
The safe has a latch closure sensor that will illuminate the LED in the keypad when
the lid is closed.
Green – Latch has fully closed.
Blinking Red – Latch has NOT fully closed.
Press lid to close or re-open and check for interference.
4. Your key code can now be used to open
the safe.
NOTE:
Only one key code can be
programmed into the safe. If you attempt
to program a second code, the previous
code will be overwritten.
A total of
5 RFID tags and 1 key code can be
programmed into the safe.
