5
to program an RFID tag fail, please contact
Hornady at 800-338-3220.a
6. One to five RFID tags can be programmed
into the safe.
WARNING:
After programming, confirm all
RFID tags are either programmed or not. All
programmed RFID tags must be kept in a safe
place to prevent use from unauthorized users.
How to Program Your
RFID Tags
Your RAPiD
®
Safe includes three (3) styles
of RFID tags, including:
• 1 Adjustable Wristband
• 1 Key Fob
• 2 Decals
*Additional RFID tags can be purchased
separately.
The RAPiD
®
Safe can store up to 5 tags.
To program these tags:
1. Open the RAPiD Safe with either the
key, an RFID tag previously programmed
by the user or the key code.
(The safe
does not ship with pre-programmed
RFID tags. An RFID tag must be
programmed by the user to work with
this safe.)
2. Locate the red program button. Press
and release the button to begin
programming an RFID tag. The first
available program location will begin to
blink.
3.
Hold the RFID tag no more than 1-inch
from the illuminated RFID reader in
the center of the top panel. If the
programming was successful, the safe
should beep two times and the available
slot should go from blinking to solid red
for approximately 10 seconds.
NOTE:
If the user attempts to program
an RFID tag that is already stored
into the safe, the safe will beep three
times and the RFID tag will not be
programmed into the duplicate slot. The
RFID tag can only be programmed into
one location.
4. Verify the RFID tag is programmed by
holding the tag over the RFID reader
with the safe open. The motor should
cycle after each scan.
5. If the RFID tag does not program into the
safe, the program function will time out
after 10 seconds and the safe will return
to normal operation. If multiple attempts
NOTE:
The RFID chip is located in the bulge of the
wristband near the clasp. It is designed to be worn on
the bottom of the wrist for maximum read distance.
RFID Chip
RFID Reader
