4
Battery Power Mode
When the RAPiD
®
Safe is unplugged and is
operating on battery power, you must press
any button on the keypad on the top panel
to activate the RFID reader.
Pressing any button on the keypad causes
the system to go from battery-saving mode
to ready status.
For example:
To open your safe with an
RFID tag while the system is running on
battery power, first press any button on the
keypad to bring it to ready status. Place
your RFID tag within 1" of the center of the
RFID reader to open the safe.
Keypad Tones On/Off
Press and hold the “H” button on the keypad
for 5 seconds until the light turns off to toggle
sound on and off.
To check battery level:
1. Disconnect from the 12V Car Adapter.
2. Press any button on the keypad.
3. The LED light near the center of the
keypad will flash.
a. Flashing Green – Good battery
b. Flashing Yellow – Low battery
c. Flashing Red – Weak battery
NOTE:
Replace batteries every 12 months
or if they become low or weak.
"H" Button
Keypad
RFID Reader
Battery & Latch
Status Light
