Air Bladder
Air Bladder
PASSENGER
SEAT
DRIVER
SEAT
console
console
8
Install the safe onto the mounting plate by
aligning the two clamp rings with the pins on the
mounting plate and tighten the four screws.
NOTE:
The safe can be tilted forward or
back by adjusting the clamp rings BEFORE
installing the screws.
Once the safe is mounted, slide the mounting
plate between the seat and center console.
Make sure the door of the safe can open
without interfering with the seat.
Inflate the air bladder by turning the
control valve clockwise and then
squeezing the inflater bulb
until the mounting
system is firmly
in place.
• Verify the air bladder is positioned onto the
mounting plate so it will inflate against the seat.
It may need to be rotated around the mounting
plate depending on if the safe will go on the
driver or passenger side of the vehicle.
• To rotate the air bladder, release all air in
the bladder by turning the control valve
counterclockwise.
• Slide the fabric cover back to expose the air
bladder on the mounting plate. Rotate the air
bladder around the mounting plate until the
inflatable air bladder is on the correct side.
• Slide fabric cover back over the air bladder.
• Begin by verifying the inflatable bladder is on
the seat side of the mounting plate by closing
the valve on the hand pump and gently inflating
the air bladder.
WARNING:
a. Do not overinflate
the air bladder.
b. The air bladder should
be inflated just enough
to hold the mounting
system in place.
c. Make sure the mounting system does not move even during hard braking by testing in a
controlled environment.
Verify system works as expected before storing a firearm or other valuables inside the safe.
