User Manual for Key Safe
WARNING
Read all instructions before using this safe.
-Test registered pin code a few times before closing
the safe door.
- Avoid leaving door open and unattended; it will allow
unauthorized individuals to reprogram the safe,
gaining full access to the safe and its contents.
- Store emergency keys in a secure place; NOT inside
of the safe.
- To maximize security and performance of the safe,
test pin code every 6 months.
- Test and make sure the safe works properly before
mounting. Once tested, mount the safe before use.
GETTING STARTED
Remove emergency keys and other included
accessories from packaging.
KEY ACCESS
1. To expose the key access, gently lift off the key cover
2. Use emergency key and insert into key hole, turn key
counter clockwise and turn handle clockwise.
BATTERY
Battery compartment is located on the inside of the door
safe.
1. Remove battery compartment cover.
2. Insert four new AA alkaline batteries into the battery
compartment and restore battery compartment cover.
Note: Do not mix new and old batteries
PIN CODE REGISTRATION
Safe retains only two 3-8 digit pin codes
1st Personal Pin Code
1. With safe open, press and release the initialization
button located on the inside of the safe door. Yellow
indicator light will be on.
2. On the key pad input your 3-8 digit pin code and
press and release either "A" or "B" to confirm. Yellow
indicator light will turn off.
2nd Personal Pin Code
1. On the keypad press “00” then press and release the
initialization button located inside of the safe door.
Yellow indicator light will be on.
2. On the key pad input your 3-8 digit pin code and
press and release either "A" or "B" to confirm. Yellow
indicator light will turn off.
TESTING REGISTERED PIN CODES
1. With safe door open, and the handle/lock knob in the
lock position. Enter in 1st personal pin code on the
key pad and press and release either "A" or "B"
to confirm.
Successful Save
- You will hear 2 short beeps
- The green indicator light will flash
- Move handle to the right to retract bolts
Unsuccessful Save
- You will hear 3 short beeps
- Handle will not move and bolts will stay extended
- Repeat steps CREATING PERSONAL PIN CODES
2. To test 2nd personal pin code, enter in 2nd personal
pin code on the key pad and press and release
either "A" or "B" to confirm. See “Successful Save”
and “Unsuccessful Save” above
3. Test a pin code that is not registered to make sure
the safe does not open to complete testing process
OPENING & CLOSING SAFE WITH PERSONAL PIN
CODES
OPEN:
1. On the key pad enter in either of your 3-8 digit pin
codes and press and release either "A" or "B"
to confirm.
2. Turn the handle/lock knob to the unlock position and
pull the safe door open
NOTE
After entering pin, you have 5 seconds to turn the knob
before the mechanism re-locks automatically
CLOSE:
To close safe, close door and turn knob to the lock
position
LOCK OUT
When the wrong pin code is entered 3 consecutive
times lock out mode will activate for 5 min; safe cannot
be used during this time; please wait or open with
emergency keys.
CHANGING PERSONAL PIN CODES
Follow steps in “PIN CODE REGISTRATION”
See reverse side for more information
855 Towne Center Drive | Pomona, CA 91767
© 2019 BARSKA®
(t) 888.666.6769 | (f) 909.445.8169 | www.barska.com
A. Handle
B. Key Access
C. Indicator Lights
D. Key Pad
E. Key Drop Slot
- Located on the side of the safe
Lock
Un
lo
ck
E
D
C
B
A
1
2
3
4
5
6
7
8
9
A
0
B
6/19
BC610
