EN
9
Center of Gravity (CG)
The CG location is measured from the leading edge of the wing at the root.
This CG location has been determined with the recommended Li-Po battery
(SPMX22003S50).
NOTICE:
Install the battery but do not arm the ESC while checking the CG.
Personal injury may result.
Tip:
Measure the CG with the aircraft inverted.
AS3X Control Direction Test
This test ensures that the AS3X
®
control system is functioning properly.
Assemble the aircraft and bind your transmitter to the receiver before
performing this test.
1. Raise the throttle just above 25%, then lower the throttle
to activate AS3X technology.
CAUTION:
Keep all body parts, hair and loose clothing away from a
moving propeller, as these items could become entangled.
2. Move the entire aircraft as shown and ensure the control surfaces move in
the direction indicated in the graphic. If the control surfaces do not respond
as shown, do not fly the aircraft. Refer to the receiver manual for more
information.
Once the AS3X system is active, control surfaces may move rapidly. This is
normal. AS3X remains active until the battery is disconnected.
Aircraft
movement
AS3X Reaction
Elev
ator
Aileron
Rudder
78-82mm
back from leading edge
of wing at the fuselage
During your first flight, trim the aircraft for level flight at 3/4 throttle with flaps
up. Make small trim adjustments with your transmitter’s trim switches to
straighten the aircraft’s flight path.
After adjusting the trim, do not touch the control sticks for 3 seconds. This
allows the receiver to learn the correct settings to optimize AS3X performance.
Failure to do so could affect flight performance.
In Flight Trimming
3 Seconds
