EN
8
V900
™
Sport Airplane
Control Horn and Servo Arm Settings
The table to the right shows the factory settings for the control horns and servo
arms. Fly the aircraft at factory settings before making changes.
NOTICE:
If control throws are changed from the factory settings, the AR631
gain values may need to be adjusted. Refer to the Spektrum AR631 manual for
adjustment of gain values.
After flying, you may choose to adjust the linkage positions for the desired
control response. See the table to the right.
Horns
Arms
Elevator
Elevator
Flaps
Tail wheel
Elevator
Flaps
Tail wheel
Ailerons
Elevator
Flaps
Tail wheel
Elevator
Flaps
Tail wheel
Rudder
Elevator
Flaps
Tail wheel
Elevator
Flaps
Tail wheel
More control throw
Less control throw
SAFE
®
Select Switch Designation
SAFE
®
Select technology can be easily assigned to any open switch (2 or 3 position)
on your transmitter. With this new feature, you now have the flexibility to enable or
disable the technology while in flight.
IMPORTANT:
Before assigning your desired switch, ensure that the travel for that
channel is set at 100% in both directions and the aileron, elevator, rudder and throttle
are all on high rate with the travel at 100%. Turn throttle hold OFF if it is programmed
in the transmitter.
Assigning a switch
1. Bind the aircraft correctly to activate SAFE Select. This will allow the system
to be assigned to a switch.
2. Hold both transmitter sticks to the inside bottom corners and toggle the desired
switch 5 times (1 toggle = full up and down) to assign that switch. The control
surfaces of the aircraft will move, indicating the switch has been selected.
Repeat the process to assign a different switch if desired.
NOTICE:
SAFE Select is assignable on any unused Channels 5–9.
Mode 1 and 2 Transmitters
3 position Switch
2 position Switch
x 5
100%
100%