EN
Carbon-Z Cessna 150T 2.1m
6
Model Assembly
Rudder Installation
1. Slide the rudder’s CA hinges
(A)
into the hinge slots
(B)
of the vertical fin. Make
sure to place the tail light and wire
(C
) on the left side of the rudder.
2. Rest the aircraft on its nose, holding the tail up so the thin CA (cyanoacrylate
adhesive) will flow into the slots.
3. Bend the hinges by turning the rudder left, then carefully apply thin CA to each
hinge in the right side of each slot.
4. When the CA is dry, turn the rudder to the right and apply CA in the left side of
each slot.
5. Place the tail light wire in the groove
(D)
and secure it into place with the
included red tape
(E)
.
6. Insert the LED
(F)
into the tail light housing
(G)
, then secure the tail light
housing onto the edge of the rudder using CA.
7. Connect the ball link
(H)
to the rudder control horn
(I)
using a screw
(J)
and
nut
(K)
. Ensure the rudder servo arm is in the correct position, then adjust the
ball link on the linkage to center the rudder.
Required Adhesives:
Thin CA
A
B
D
E
F
G
H
I
C
K
M2 lock nut
J
M2 x 8mm
Tip:
There are spare screws included with the airplane in case a fastener is lost.
