EN
Carbon-Z Cessna 150T 2.1m
14
Battery Selection
We recommend the Spektrum 5000mAh 22.2V 6S 30C Li-Po battery
(SPMX50006S30). Refer to the Optional Parts List for other recommended
batteries. If using a battery other than those listed, the battery should be within the
range of capacity, dimensions and weight of the Spektrum Li-Po battery packs to fit
in the fuselage. Be sure the model balances at the recommended CG.
CAUTION:
Always keep hands away from the propeller. When armed, the
motor will turn the propeller in response to any throttle movement.
C
CAUTION:
Always
keep hands away
from the propeller. When
armed, the motor will turn
the propeller in response
to any throttle movement.
B
A
1. Lower the throttle and throttle trim to the lowest settings. Power on the
Transmitter, then wait 5 seconds.
2. It is recommended to apply hook and loop tape
(A)
to the bottom of your
battery.
3. Remove the battery hatch
(B)
by pulling up on the side tabs.
4. Install the fully charged battery
(C)
in the battery compartment as shown.
See
the Adjusting the Center of Gravity instructions for more information
.
5. Make sure the flight battery is secured using the hook and loop straps.
6. Connect the battery to the ESC.
7. Keep the aircraft level on its wheels, immobile and away from wind or the
system will not initialize.
Once armed:
• The ESC will sound a series of tones (number of tones depend on the cell
count of the battery).
• The control surfaces will cycle once for AS3X or twice for SAFE technology if
it is turn ON.
• An LED will light on the receiver.
8. Reinstall the battery hatch.
When needed, disassemble in reverse order.
IMPORTANT:
The ESC comes programmed for a 6-cell battery. To use a battery
with a different cell count you must first reprogram your ESC. Refer to your
ESC manual for instructions to reprogram the ESC for a different cell count.
REMOVE!!!!!!!!!!
Battery Installation and ESC Arming
