Horizon Hobby Axial CAPRA AXI03000, Инструкция по эксплуатации, Страница: 6 / 56

6
EN
INSTALL THE TRANSMITTER BATTERIES
TRANSMITTER FUNCTIONS
This transmitter requires 4 AA batteries.
1. Remove the battery cover from the transmitter.
2. Install the batteries as shown.
3. Install the battery cover.
CAUTION: NEVER remove the transmitter batteries while the model
is powered on. Loss of model control, damage, or injury may occur.
CAUTION: If using rechargeable batteries, charge only rechargeable
batteries. Charging non-rechargeable batteries may cause the
batteries to burst, resulting in injury to persons and/or damage to property.
CAUTION: Risk of explosion if battery is replaced by an incorrect
type. Dispose of used batteries according to national regulations.
2.4GHZ DIGITAL
RADIO SYSTEM
Top
Bottom
A. Servo Reversing
To reverse the Throttle (TH) or Steering (ST) channel, switch the position
of the correlating switch—“N” is for normal, “R” is for reverse.
B. Throttle Trim
Adjusts the throttle neutral point
C. Steering Trim
Adjusts the steering center point. Normally, the steering trim is adjusted
until the vehicle tracks straight.
D. Throttle Rate
Adjusts the end point of the throttle
E. Steering Rate
Adjusts the end point of the steering
F. Indicator Lights
• Solid red lights: Indicates radio connectivity and adequate battery
power
• Flashing red lights: Indicates the battery voltage is critically low.
Replace batteries
G. Throttle Limit
Limits throttle output to 50/75/100%
Select 50% or 75% for less experienced drivers or when you are driving
the vehicle in a small area.
H. Antenna
I. Power Button
J. Throttle/Brake
K. Steering Wheel
L. Channel 3 Buttons
: Top and Bottom
A
B
D
F
E
G
J
H
K
C
I
L
Follow the manufacturer’s directions for your charger to properly charge
the vehicle battery.
CAUTION: Only use chargers designed to charge the chosen
battery type. Using an incompatible charger or incorrect charge
settings could result in fi re causing person injury or property damage.
CHARGE THE VEHICLE BATTERY
SETTING TRAVEL ENDPOINTS FOR CHANNEL 3
Follow the instructions below to set the travel endpoint of an accessory or servo on channel 3 if needed:
1. Press and hold the CH 3 “Top” button, while powering ON the
transmitter. Continue to hold the Top button until the transmitter LED
fl ashes 5 times.
2. Release the Top button
3. Use the CH3 Top and Bottom buttons to adjust the accessory or servo
to the desired fi rst end point position.
4. Turn the steering wheel fully clockwise (right) to confi rm the fi rst position.
The LED will fl ash once to confi rm the fi rst position has been saved.
5. Use the CH3 Top and Bottom buttons to adjust the accessory or servo
to the desired second end point position.
6. Turn the steering wheel clockwise (right) to confi rm the second
position. The LED will fl ash twice to confi rm the second position has
been saved.
7. Power off the transmitter to save the settings