Horizon Hobby Axial CAPRA AXI03000, Инструкция по эксплуатации, Страница: 10 / 56

10
EN
TROUBLESHOOTING
Battery ESC
Red
Black
Motor
PROBLEM POSSIBLE CAUSE SOLUTION
Vehicle does not move
Batteries are not installed properly in the
transmitter
Ensure the transmitter batteries are properly installed
Weak or no battery in the vehicle Install a freshly charged vehicle battery
Damaged motor Replace the motor
Frayed or broken wiring Replace any damaged wiring
ESC is shut down by heat protection circuit Allow the ESC to cool down completely
Loss of vehicle control
Improper antenna placement
Ensure the transmitter antenna is not blocked and the receiver
antenna is located properly
Weak or no batteries in the transmitter or
vehicle Install a freshly charged vehicle battery and new transmitter
batteries
Neutral or trim position is incorrect Adjust the steering trim
Receiver and/or battery not connected
properly
Check all receiver and battery connections
Steering and/or throttle function is reversed
Servo travel is reversed at the transmitter Set the transmitter servo reversing switch to the correct position
Motor wires are not connected properly Check all motor wires for correct polarity and secure connection
AE-5L FORWARD/REVERSE ESC WITH DRAG BRAKE
SETUP
Throttle calibration should not be needed out of the box. However, in order
to make the throttle range of different transmitters, the calibration of the
ESC is necessary:
• Mount the ESC in an area that is well ventilated and isolated from
vibration and shock.
• Connect the ESC motor wires to the motor red-to-red and black-to-black.
• Plug the receiver into the throttle channel of the receiver.
• Before plugging the battery into the ESC, make sure your transmitter is
on and the throttle trim is set to zero.
• Connect the battery to the ESC. The vehicle will be powered on when the
battery is connected.
CAUTION: Keep all body parts and loose clothing away from any
moving parts while the battery is connected to the ESC.
CAUTION: Always connect the ESC only to a proper power
source that has the correct voltage and polarity. Incorrect
voltages or reversed polarity will damage the ESC. Damage to the ESC
caused by improper voltage or polarity is not covered under warranty.
• Test forward and reverse control using the transmitter.
To calibrate the ESC:
• Power the transmitter on and set the throttle control to neutral.
• Connect the battery to the ESC and wait 3 seconds to let the ESC initiate
a self-test and automatic throttle calibration.
• The ESC is ready to run when a long beep sound is emitted from the motor.
• Always disconnect the battery when the vehicle is not in use.
NOTES
• The drag brake is set to 100% from the factory.
• The LiPo cut-off is set to “ON” from the factory.
ESC SPECIFICATIONS
Input Voltage 2-3S LiPo, 5-9 Cells NiMH/NiCd
Size 46.5mm x 34mm x 28.5mm
Weight 70g
Motor Limit 12T 2S/18T 3S
On-Resistance FET .002
Rated/Peak Current 180A
Braking Current 90A
BEC Voltage/A 6.0V 3.0A Peak
PWM Frequency 1KHz
ESC SOUND STATUS
1 Short Beep Battery is NiMH/NiCd
2 Short Beeps Battery is 2S LiPo
3 Short Beeps Battery is 3S LiPo
1 Long Beep
Self-test and throttle calibration
is OK and ESC is ready to run
To Receiver
Throttle Channel