Roller Replacement
Tools required:
Philips screwdriver
T-handle Allen wrench (6mm, 8mm)
Procedure:
Front roller
1. With a Philips head screwdriver, remove the motor cover.
2. With the Philips head screwdriver, remove the speed sensor. Press your finger
against the drive belt and guide it towards the left until it is released from the front
roller.
3. With the 6mm Allen wrench, remove the front roller and replace it with a new one.
It is a good idea to note the position of the front roller before removing. For best
results, place two removable marks on the left and right side of the deck and the
running belt. When reinstalling, match up the marks for proper tension.
4. Reassemble the front roller and the drive belt. Install the motor cover.
Rear roller
1. With a Philips head screwdriver, remove the motor cover.
2. With the appropriate size Allen wrench remove the rear roller and replace it with a
new one.
It is a good idea to note the position of the rear roller before removing.
3. Start the treadmill, and run it to ensure proper belt tension and side-to-side belt
tracking. If there is a problem with the belt tension or tracking, adjust the rear
roller position.
58
