©2017, 2018, 2019 Horizon Global™ Corp. –
Printed in Mexico
Sheet 18 of 60
24964NP
06-24-19
Rev. C
Electrical
3. (C). Remove Fascia and Bumper Beam Assembly
–
Using a 12mm
socket, remove (2) M8 bolts holding bumper beam to end panel,
both sides. Return existing M8 bolts to vehicle owner.
Bolts
3.
(D). Remove Fascia and Bumper Beam Assembly
–
Using a plastic
trim tool, remove the fascia and bumper beam assembly starting
at the outer edges near wheel wells while gently pulling rearward
on the fascia. Disconnect the wiring harness from fascia if present.
4.
Remove Lower Fascia from Upper Fascia
–
Using a flat head screw driver,
remove (2) push pin rivets from bottom edge of fascia, (1) per side. Using
a plastic trim tool, unclip all tabs from lower fascia.
Note:
Lift the foam piece above the bumper beam to gain access to
some of the tabs.
5. Remove Support Brackets
–
Using a phillips head screw driver,
remove (2) plastic fascia support brackets from bumper beam and
return to vehicle owner.
Push Pin
Location
KIA MODELS
KIA MODELS
KIA MODELS
KIA MODELS