©2017, 2018, 2019 Horizon Global™ Corp. –
Printed in Mexico
Sheet 11 of 60
24964NP
06-24-19
Rev. C
5. (B). Remove Center Section
–
Disengage retention clips around
perimeter of fascia center section. Set fascia section aside.
5. (C). Remove Support Brackets
–
Using a phillips head screw driver and
trim tool, remove screw and push pin rivet from fascia support
bracket. Remove (3) plastic fascia support brackets from bumper beam
and return to vehicle owner.
5. (A). Disassemble Fascia
–
Remove signal lights: Remove (4) phillips
screws, unhook electrical connection, disengage retention clip. Set
lamp assembly aside. Repeat on other side of vehicle.
HYUNDAI MODELS
HYUNDAI MODELS
HYUNDAI MODELS
Screws
Retention Clip
Electrical Plug
4. (E). Unclip Fascia
–
Using a plastic trim tool, remove the fascia and
bumper beam assembly starting at the outer edges near wheel wells
while gently pulling rearward on the fascia. Disconnect the wiring
harness, located near driver side taillight.
HYUNDAI MODELS
Area of fascia to remove