Carpet height
adjustment
The cleaning of carpet and rugs
takes place at the nozzle (A).
When it is necessary to raise and
lower the nozzle for various carpet
pile heights, slide the nozzle control
knob (B) to the desired setting.
2-9
Settings
For maximum cleaning perfor-
mance,
the following carpet height
settings are recommended:
•
Lowest setting:
for all types of
carpet
Note:
If the cleaner is difficult to
push, slide knob to the next higher
setting.
•
Higher settings:
for very deep
pile carpet where easier pushing
effort is desired, while maintaining
good cleaning performance.
Handle positions
The handle of your cleaner has three
positions;
upright
for storage and
when using cleaning tools;
operating
position
for general operation on
carpet and floors;
low
for reaching
under low furniture. Step on handle
release lever to lower handle.
Carrying cleaner
The cleaner can also be moved by
using the carrying handle.
Transporting cleaner
To move your cleaner from room to
room, put handle in upright position,
tilt cleaner back on rear wheels and
push forward.
6
2-5
2-3
2-7
2-6
2-4
A
B
Embedded DirtFINDER™
feature
(some models only)
With red and green lights (A), the ‘Dirt
FINDER’ system alerts the user to
areas of carpet that may need more
cleaning attention. It is able to sense
when larger amounts of dirt particles,
especially embedded dirt, are
removed.
To let you know that the ‘DirtFINDER’
feature is ready, the red light will
Handle position
For ease in sliding knob, the handle
should be in the upright position (C).
The nozzle will not move into the
adjusted position until the cleaner
handle is lowered to the operating
position (D).
C
D
A
B
HIGH
BARE
FLOOR
2-8
come on when the cleaner is first
turned on. After a few seconds, the
red light will go off and the
green
light
will come on.
Cleaning may
then begin.
The
green light will remain on
throughout cleaning
except
when
the detector senses that a
larger
amount of dirt
is being picked up;
then the
red light
will come on.
When the
red light
is on, you should
take additional cleaning strokes
in
the area until it changes to green.
•The red light may seldom come on
during cleaning. This means that
your cleaner is picking up primarily
fine surface dust and lint which the
system may not detect, or that the
carpet is generally clean.
To
increase
the feature’s
sensitivity to
dirt
, set the switch (B) to the
“Hi”
position.
•At other times, the red light may
stay on for a considerable amount of
time. This means that the carpet
contains a high level of dirt which is
being removed by the cleaner.
To
decrease
the feature’s
sensitivity to
dirt
, set the switch to the
“Reg.”
(Regular) position.
