Cleaning final filter
The
final filter
assists in the filtra-
tion process to return clean air to
the room.
To remove this filter when it be-
comes dirty, open the door on the
side of the cleaner.
Lift out filter (B) and hand wash it in
cold water with mild detergent.
Let filter air dry and reposition it on
the side of the cleaner. Make sure
the green colored side of filter faces
outward. Close door.
Should you want to replace this fil-
ter, ask for
HOOVER part No.
40110004.
Do not operate cleaner without
either the secondary or final filter
in place.
Cleaning secondary filter
Disconnect cleaner from electrical
outlet.
The
secondary filter (A)
, located
behind the grill in the bottom of bag
compartment, protects the motor
from dirt particles.
If filter becomes dirty, pull off grill
and lift out filter.
Hand wash filter in cold water with
mild detergent, then air dry.
Reposition dry filter and grill.
Should you want to replace this filter,
ask for
HOOVER part No. 38765019.
Replacing bag door
Reposition bag door by placing tabs
on bottom of door into opening (C).
Press top of door to snap securely
shut.
9
3-5
3-1
3-2
A
B
C
A
C
B
Removing and installing filter
bag
Grasp filter bag collar (A) and pull
collar from tube (B).
Note: Do not clean out old filter bag
and reuse. Discard used filter bag.
Hold new filter bag as shown. Align
opening in filter bag with (B).
Push (A) firmly onto (B).
Tuck in filter bag.
Removing bag door
To change filter bag, press down at
top of bag door and pull door for-
ward.
Remove door.
Secondary and final
filters
3-6
Reattaching filter door
The filter door is designed with a
“break-away“ feature which allows it
to snap free if it is pushed open too
far.
To reattach, align hinges (C) of
cover with slots on sides of filter
area.
Press door back into place.
Check agitator shield
Because your cleaner picks up so
well, we strongly recommend you
check for debris accumulation
under the agitator shield each time
you clean the filters.
Removing debris under the shield
will help maintain your cleaner’s
excellent pick up and suction.
Remove debris as follows:
1. Disconnect cleaner from electri-
cal outlet.
2. Check for dirt accumulation by
removing bottom plate (Fig. 3-10),
removing agitator (Fig. 3-11), and
lifting agitator shield (Fig. 3-13).
3. Remove any debris and replace
shield, agitator and bottom plate
(Figs. 3-13 to 3-15).
Changing filter bag
Disconnect cleaner from electrical
outlet.
3-3
3-4
