The extra nut is not required but has been
provided for your convenience.
Attach tool holder
Remove tool and taped screw from hold-
er. Insert projections on holder into slots on
4
Push
bolts
into holes on
front of handle. If
bolts will not go through hole easily han-
dle is not pushed completely down.
1-2
When handle sections are completely
together, squeeze trigger (C) on upper
handle to snap trigger rod in place.
Replace clean solution tank (upper tank) by
positioning bottom first. Press on tank han-
dle to snap top of tank into place.
Press cord into cord clip on back of hose
holder. Pull cord tight.
Attach hose holder
Position hose holder (B) onto handle by
1-3
1-6
1-9
1-4
1-5
1-7
1-8
matching tabs on rack with openings on
back of handle. Make sure bolts are through
holes.
A
C
B
Place
nuts
in recessed areas on
back of
hose holder.
Hold each nut in place while
tightening each bolt securely (from the
front of the handle) with a Phillips screw-
back of cleaner.
Slide holder down into place. Insert screw
at (D) and tighten with a Phillips screw-
driver.
Storing hose
Stretch hose out and identify ends.
E. Nozzle connector end of hose
G. Solution tube
F.
Trigger
H. Converter end of hose
Note:
You may find it helpful when storing
the hose to refer to the
information on
the back of the carpet cleaner and on
the converter end of the hose.
Start with converter end of hose (H). Fit
converter over tab near tool holder (I). Press
D
