92
93
If the fault should persist, contact a Technical Assistance Centre. For prompt servicing, give the
model of the washing machine, to be found on the label placed on the cabinet inside of the
porthole or on the guarantee certificate.
Important
1 The use of environment friendly detersives without phosphates may produce the following
effects:
- The discharge rinse water may result cloudier due to the presence of zeolites in suspension.
This does not compromise the efficiency of the rinses.
- The presence of white powder (zeolites) on the washing at the end of the washing cycle. This
does not remain incorporated in the fabric and does not alter the colour.
- The presence of foam in the last rinse water which is not necessarily a sign of inadequate
rinsing.
- The non-ionic surface-active agents present in the composition of washing machine
detersives are often difficult to remove from the washing itself and, even in small quantities,
may produce visible signs of the formation of foam.
- Carrying out further rinses, in cases such as this, is not useful.
2If your washing machine fails to function, carry out the above-mentioned checks before calling
the Technical Assistance Service
.
RECOMMENDATIONS ON THE USE OF DETERGENT AT VARIOUS TEMPERATURES.
When washing heavily soiled whites, we recommend using cotton programs of 60°C or
above and a normal washing powder (heavy duty) that contains bleaching agents
that at medium/high temperatures provide excellent results.
For washes between 40°C and 60°C the type of detergent used needs to be
appropriate for the type of fabric and level of soiling.
Normal powders are suitable for “white” or colour fast fabrics with high soiling, while
liquid detergents or “colour protecting” powders are suitable for coloured fabrics with
light levels of soiling.
For washing at temperatures below 40°C we recommend the use of liquid detergents
or detergents specifically labeled as suitable for low temperature washing.
For washing wool or silk, only use detergents specifically formulated for these fabrics.
For dosage amounts please follow the instructions on the detergent package label.
NOTE:
THE INITIAL SPIN AT THE BEGINNING OF THE WASHING CYCLE IS A NORMAL PHASE OF THE
PROGRAM AND NOT A MACHINE FAULT.
CHAPTER 13
EN
FAULT
1. Does not function
on any programme
2. Does not load
water
3. Does not discharge
water
4. Water on floor around
washing machine
5. Does not spin
6. Strong vibrations
during spin
7. Display reads error
0, 1, 5, 7, 8
8. Display reads
error 2
9. Display reads
error 3
10. Display reads
error 4
11. Display reads
error 9
Mains plug not plugged in
Mains switch not on
No power
Electric circuit fuses failure
Load door open
See cause 1
Inlet tap turned off
Timer not set correctly
Discharge tube bent
Odd material blocking filter
Leak from the washer between the tap
and inlet tube
The washing machine has not
discharged water
“No spin” setting (some models only)
The presence of excessive foam has
aborted the spinning phase
Washing machine not perfectly level
Transport bracket not removed
Washing load not evenly distributed
–
No water fill.
No pump out.
Machine overfilled with water.
–
Insert plug
Turn on mains switch
Check
Check
Close load door
Check
Turn on water inlet tap
Set timer on correct position
Straighten discharge tube
Check filter
Replace washer and tighten the tube
on the tap
Wait a few minutes until the machine
discharges water
Turn the programme dial onto spin setting
Do not use excessive amounts of
detergent
Adjust special feet
Remove transport bracket
Distribute the washing evenly
Call service.
Check water supplies are on.
Check drain is clear.
Check drain hose is not kinked.
Turn off water supply to machine.
Call service.
Switch off the appliance
Wait 10-15 seconds and start again the
programme
CAUSE
REMEDY
Содержание DYN P8
Страница 94: ......