Hoover BRUSH N WASH, Инструкция по эксплуатации

Страница: 4 / 43

4
With cord hook (B) to back of clean-
er, push upper handle down onto
lower handle.
5
9
6
3
3
4
7
8
11
Push
bolts
into holes on
front of
handle. If bolts will not go through
hole easily, handle is not pushed com-
pletely down.
E
F
C
B
Place
nuts
in recessed areas on
back of handle
. Hold each nut in
place while tightening each bolt secure-
ly with a Phillips screwdriver. Only two
nuts are needed on this model. The
extra nut is not required, but has been
provided for your convenience.
When handle sections are com-
pletely together, squeeze trigger
(C) on upper handle to snap trigger rod
in place.
Replace clean solution tank (upper
tank) by positioning bottom first.
Press on tank handle (D) to snap top of
tank into place.
Press cord into cord clip on back
of handle. Pull cord tight.
A At tt ta ac ch h llo ow we er r h ho os se e
h ho olld de er r
With front of cleaner resting on
floor, place 2 projections (E) on
lower hose holder into 2 holes (F) on
back of cleaner.
D
S St to or riin ng g h ho os se e a an nd d
n no oz zz zlle e o on n r ra ac ck k
Stretch hose out and identify
ends.
G. Nozzle connector end of hose
H. Solution tube
I. Trigger
J. Converter end of hose
Note:
You may find it helpful when stor-
ing the hose and nozzle to refer to the
information on the back of the cleaner
and on the converter end of the hose.
G
H
I
J
10
Push screw into hole and tighten
securely with a Phillips screw-
driver.
4
5
6 7
8
9
10
11