Hoover BRUSH N WASH, Инструкция по эксплуатации

Страница: 12 / 43

42 43
44
46
12
Replace panel with converter (D).
Slide converter halfway down
opening until it is firmly in place.
Before connecting tube (E) to
cleaner, make sure black tabs
are extended by pulling tan collar
toward tube.
Open door on hood labeled “Stair/
upholstery Cleaning Connection”. Press
round solution tube connector onto
round projection inside door.
Press con-
nector collar down firmly to ensure
that it is fully connected.
When the solution tube is connected
to the cleaner, the nozzle brushes will
automatically be turned off and will
not rotate when the cleaner is turned
on even if the speed selector is in the
HI or LO position.
The tank lid replaces in a
hinge-like manner.
Position front
of lid under tabs (F) on front of tank.
Rotate lid down onto tank.
Make sure lid is secure on all sides
before cleaning.
For full suction, it is important that
the recovery tank lid is properly
secured before cleaning.
Reverse procedure to remove hose
and solution tube.
Raise cleaner handle to upright position.
How to attach stair/
upholstery nozzle
Attach nozzle to connector end
of hose by sliding it onto con-
nector (G) until the tab (H) locks it
securely.
Using your thumb,
push forward and
up
on the latch (I) to remove tool as
shown.
Follow the instructions on pages 13 and
14 for the appropriate cleaning task.
H
G
I
F
D
E
45
A Af ft te er r u us siin ng g
s st ta aiir r//u up ph ho olls st te er ry y n no oz zz zlle e
Follow steps a and b for “After cleaning”
on page 10.
Drain suction hose by turning cleaner
ON and holding end of hose up for sev-
eral seconds.
Do not press trigger.
Unplug the cleaner from electrical
socket. Disconnect hose and solution
tube from cleaner.
Drain solution tube by placing
round end in sink and raising
nozzle above your head. Press the trig-
ger.
Proceed with steps c, d and e for “After
cleaning” on page 10.
42 43 44
45
46