Hoover BRUSH N WASH, Инструкция по эксплуатации

Страница: 15 / 43

15
S St to or ra ag ge e
Before storing:
• Empty solution tank and rinse
thoroughly with clean water.
• Replace
empty
solution tank and
turn cleaner ON. Squeeze
trigger and push cleaner forward
and back several times to expel
any solution remaining in the
cleaner’s system. (Do not use
cleaner on wood floors.)
• Empty recovery tank and rinse
thoroughly with clean water.
Allow brushes and underside of
cleaner to air dry thoroughly before
storing cleaner on a carpeted or wood
surface.
Do not store cleaner with a full solu-
tion tank In place.
Lubrication
The motor is equipped with bearings
which contain sufficient lubrication for
the life of the motor. The addition of lubri-
cant could cause damage.
Do not add
lubricant to motor bearings.
Service
Use only genuine Hoover spare parts.
Always identify your cleaner by the com-
plete model number when requesting
information or ordering parts. (The
model number appears on the back of
the cleaner handle.)
IMPORTANT
Cord Replacement
This HOOVER appliance is supplied
complete with a plug. For the UK, the
plug is fitted with a 13 Amp fuse.
If the main cord of this appliance is
damaged, the appliance must be
repaired by an Authorised Hoover
Repairer to avoid a safety hazard.
• Speed selector on OFF
•
Move speed selector to Low or Hi
• Solution tube connected to “Stair/
upholstery cleaning connection”
•
Remove stair/upholstery nozzle for
floor cleaning (Fig. 44)
Guarantee
Statement
The guarantee conditions for this appli-
ance are as defined by our representa-
tive in the country in which it is sold.
Details regarding these conditions can
be obtained from the dealer from whom
the appliance was purchased. The bill of
sale or receipt must be produced when
making any claim under the terms of this
guarantee. Subject to change without
notice.
If a minor problem occurs, it usually can
be solved quite easily when the cause is
found by using the check list below.
Problem: Machine wonʼt run
Problem: Low suction
Problem: Clean solution wonʼt
dispense
Possible cause
Possible solution
• Not firmly plugged in
•
Plug unit in firmly
• No voltage at electrical socket
•
Check fuse or breaker
• Blown fuse/tripped breaker
•
Replace fuse/reset breaker
Possible cause
Possible solution
• Recovery tank lid not on correctly
•
Make sure lid is on securely (Fig. 32)
• Blockage in nozzle on end of hose
•
Remove nozzle and clear blockage
• Recovery tank full/automatic shut
off engaged
•
Remove and empty recovery tank
• Recovery tank front panel not
replaced after stair or upholstery
cleaning
•
Replace recovery tank front panel
(Fig. 41)
Possible cause
Possible solution
• Solution tank not firmly in place
•
Make sure tank is securely locked in
position
• Solution tank empty
•
Refill tank according to instructions for
surface being cleaned (Figs. 23-29)
• Recovery tank lid not on
correctly
•
Make sure lid is firmly in place (Fig.
32)
•
Stair/upholstery solution tube not
securely fastened
•
Make sure tube is securely fastened
at hood connection
Possible cause
Possible solution
• Indicator screen dirty
•
Remove clear cover over indicator
and clean screen; replace cover (Fig. 22)
If you have a
problem
WARNING!
ELECTRICITY CAN BE
EXTREMELY DANGEROUS.
THIS APPLIANCE MUST BE
EARTHED.
*HOOVER and are registered
trademarks
Problem: Brushes/brush indicator
wonʼt rotate during floor cleaning