honle LED Cube 100, Руководство по эксплуатации

Страница: 9 / 20

# 69136a
9
Thermal hazards
The following precautionary measures must be observed when operating
the LED Cube 100:

Only operate the radiation component when it is fixed securely to the
irradiation chamber.

Never leave the unit unattended when an irradiation procedure is tak-
ing place. The intensive radiation in the irradiation chamber causes the
product inside the chamber to heat up. Allow the products to cool down
before removing them.

The UV emitter must not be operated in areas with an explosive at-
mosphere.

Do not irradiate highly flammable or combustible substances in the ir-
radiation chamber.
WARNING!
The interior of the LED Cube 100 and the units being ir-
radiated can heat up during the process.
Danger from gases
Under certain circumstances, chemical vapours can be released when ma-
terials are irradiated.

The safety data sheets for the materials being irradiated must be ob-
served.

The provisions relating to materials in the workplace which are hazard-
ous to health must be taken into account.

If necessary, personnel should use breathing protection and ensure
that the workplace is sufficiently ventilated.

The air pollution in the workspace must be measured when starting
operation. If there is a high level of air pollution, a ventilation and ex-
traction system must be set up.

The commonly used UV-hardening adhesives do not release any va-
pours when irradiated with the LED Spot 100.

UV radiation promotes the production of ozone. The workspace must
therefore be sufficiently ventilated.
Thermal
hazards
Danger from
gases