7
REMOTE THERMO HYGROMETER SENSOR
FEATURES
•
Remote data transmission to the main unit via 433 MHz signal
•
328 feet (100 meters) operating range without interference
•
LCD displays temperature, humidity and channel
•
Five (5) transmission channels selection
•
Case can be wall mounted using built-in hanger
A. LED INDICATOR
•
Flashes once when the remote sensor transmits a reading to the main unit.
•
Flashes twice when battery power is low.
B. BATTERY COMPARTMENT
Holds two AA-size batteries
C. RESET
Resets all previous settings
D. CHANNEL SWITCH
Selects the desired channel from 1 to 5
E. WALL-MOUNT RECESSED OPENING
Keeps the remote sensor on the wall
Note: Install the batteries and select the channel before mounting the sensor.
BATTERY INSTALLATION
•
Remove the screws from the battery compartment with a small Phillips
screwdriver.
•
Set the channel 1 through 5. The switch is located in the battery
compartment. Channel 1 is typically selected if only one remote sensor is being
used.
•
Install 2 “AA” size alkaline batteries (not included) matching the polarities
shown in the battery compartment.
•
Replace the battery compartment door and secure the screws.
•
Secure the thermo-hygrometer remote sensor in the desired location.
MOUNTING
•
The remote thermo-hygrometer sensor can be placed on the flat surface or
8
mounted on the wall in vertical position
•
Use the wall mount hardware and screws provided when mounting the
thermo-hygrometer sensor on the wall
PLACEMENT
•
The remote thermo-hygrometer sensor should be placed in the area with a free
air circulation and sheltered from the direct sunlight and an extreme weather
conditions.
•
Ideally, place the thermo-hygrometer sensor above the natural surfaces (such
as a grassy lawn).
•
Avoid placing the thermo-hygrometer sensor near sources of heat such as
chimneys and heating elements.
•
Avoid any areas collecting and radiating a heat from the sun, such as metal,
brick or concrete structures, paving, patios and decks.
•
The international standard for the valid air temperature measurements is 4 feet
(1.25meters) above the ground.
OPERATION
Immediately after batteries are correctly installed, the remote sensor will start transmitting
a temperature and humidity data to the main unit.
RAIN GAUGE
FEATURES
•
Precipitation measurement
•
Remote transmission of the rainfall data to the main unit via 433 MHz signal
•
Operating range of up to 100 feet (30 meters)
•
Built-in installation level
•
Non-corrosive protective screen
A.
Rain gauge bucket
Holds all rain gauge components
B.
Knob
Secures the top on the rain gauge bucket
B
A
C
