Honeywell SK-Beam, Инструкция по установке и обслуживанию

Страница: 9 / 14

9 I56-3433-004
04-12
APPENDIX I. OPERATION MODES AND TROUBLESHOOTING GUIDE
Modes
*Red
See
Note
Below
Yellow,
Remote
Trouble
*Green
See
Note
Below
Remote
Alarm Dual Digital Display Initiating means Comments & Troubleshooting Tips
Normal Off Off Blink Blink Off Successful completion of
initialization or detector reset
Alignment Off On Blink Blink On, Relative amount
of signal 0-99, or – if
automatic gain resetting,
or Lo if signal is too low
Alignment Switch
Alarm On Off Off On Off Smoke, Test Filter, RTS451/
RTS151 Test Stations
Trouble: Drift
Compensation,
Elevated Signal Off 3 Quick
Blinks
Blink Blink Off Long Term Drift Reference Out of
Range • Sunlight into detector or reflector.
• Re-Align detector.
Trouble: Drift
Compensation,
Reduced Signal Off 2 Quick
Blinks
Blink Blink Off Long Term Drift Reference Out of
Range • Clean detector and reflector.
Trouble: Signal
Over Range Off 2 Quick
Blinks
Blink Blink Off Increase of Reflected Signal • Inspect line of sight between detector and
reflector for reflective objects in the pathway.
Trouble: Beam
Blockage
Response Off 4 Quick
Blinks
Blink Blink Off Beam Blockage • Remove blockage.
• Faulty unit.
Initialization:
Power on Off Blink until
complete
Blink Blink Off Apply Power from discharged state.
Initialization:
alignment exit Off Blink until
complete
Blink Blink Off Depressing RESET switch after
alignment
Local Test
(SK-Beam-T)
Pass Result On Blinking
the
amount of
drift used
Off On Off Panel or RTS451, RTS451KEY,
RTS151, or RTS151KEY Remains in alarm until reset or time-out
Local Test
(SK-Beam-T)
Fail Result Off On until
reset or
time-out
Blink Blink Off Panel or RTS451, RTS451KEY,
RTS151, or RTS151KEY test input Remains in fault until reset or time-out
Local Test
(SK-Beam)
Fail Off On until
reset or
time-out
Blink Blink Off Panel or RTS451, RTS451KEY,
RTS151, or RTS151KEY test input Remains in fault until reset or time-out
Local Test
(SK-Beam)
Pass Result On Blinking
the
amount of
drift used
Off On Off Panel or RTS451, RTS451KEY,
RTS151, or RTS151KEY Remains in alarm until reset or time-out
Note: Green and Red LEDs are controlled by the control panel.
Blinks output by Yellow LED and Remote Trouble Output once the device has
passed a local remote test:
Percent the detector has drifted Number of blinks output
<10% None
<20% 1
<30% 2
<40% 3
<50% 4
<60% 5
<70% 6
<80% 7
<90% 8
<100% 9