Honeywell SK-Beam, Инструкция по установке и обслуживанию

Страница: 5 / 14

5 I56-3433-004
04-12
FIGURE 6. WIRING CONNECTIONS AT DETECTOR
SLC (–
)
SLC (+) SLC (–
)
SLC (+) RESET
I NPUT
TEST
INPU
T
AUX (–) REMOTE
ALARM OUT
NOT
USED
REMOTE
TROUBLE OUT
TEST
OPTION (–)
TEST
OPTION (+)
T3 T2 T1
C0260-01
FIGURE 7. WIRING DIAGRAM
+ ñ
+ ñ
+
+
TO NEXT
DEVICE
FROM PANEL OR
PREVIOUS DEVICE
LISTED
REMOTE
POWER
SOURCE
* Only used for
SK-BEAM-T. See
electrical ratings.
COMMUNICATION LINE
32 VDC MAX.
TWISTED PAIR IS
RECOMMENDED.
ñ
ñ
ñ
+
T3 T2 T1
C0335-03
FIGURE 8. WIRING DIAGRAM (RTS451/RTS151)
RTS451/RTS451KEY
or RTS151/RTS151KEY
DETECTOR
PIN 1
REMOTE ALARM OUT
T2-1
T2-2
T2-4
T2-3
AUX (–)
SLC IN + T1-1
T1-2 T1-3
T1-4
SLC IN –
SLC OUT +
SLC OUT –
RESET INPUT
TEST INPUT
T3-3 REMOTE TROUBLE OUTPUT
OPTIONAL YELLOW LED
PIN 2
PIN 4
PIN 3
PIN 5
C0328-06
FIGURE 9. WIRING DIAGRAM (RTS451/RTS151)
BDT-SS
Alarm
Signal
Circuit
(Note 1)
T2-1
T2-2
Note 1: See electrical ratings section of this
manual for cir cuit output ratings.
SLC (+)
SLC ( –)
Red
C0369-00
INSTALLATION / ALIGNMENT
Reference Figures 10 through 14 for installation, alignment, and maintenance.
Please make sure to complete all steps in order to ensure a successful installa-
tion. Proper application, mounting, alignment, and set-up will minimize false
alarms and nuisance trouble signals.
PRE-ALIGNMENT CHECKLIST
• Insure that both the detector and reflector are mounted securely to stable
surfaces.
• Insure that all wiring is correct.
• Insure that terminal blocks are fully seated into their receptacles on the
detector.
• Complete any wiring dressing to minimize movement to the detector once
the alignment procedure is completed.
• Insure that the appropriate number of reflectors are used for the installed
distance. Distances between 230 and 328 Feet (70 – 100 m) require ad-
ditional reflectors (4 total). The BEAMLRK accessory should be used in
these cases.
• Insure that the line of sight between the detector and reflector is clear
and that reflective objects are not too near. See Mounting Instructions
for more details.
• Insure that both the detector and reflector are mounted within their
operational parameters for off axis angles. See Mounting Instructions
for more details.
• Disable the zone or system to prevent unwanted alarms before applying
power.
• Insure power to the detector is “ON”.
• Insure that the appropriate address is set on the code wheels.
You are now ready to begin the alignment procedure.