Honeywell Rapid Eye Hybrid LT, Руководство по установке

Страница: 56 / 86

56
Site Hardware
1. Mount a monitor where you plan to have it display a video feed. For NTSC cameras,
use an NTSC video monitor; for PAL cameras, use a PAL monitor. Do NOT place a
monitor on top of the Rapid Eye unit.
2. Connect a coaxial cable to the INPUT of the video monitor.
3. Connect the other end of the coaxial cable to SPOT MONITOR connection, at the
back of the Hybrid LT DVR.
4. Using the View application, run a Maintenance session.
5. Click the
Monitor Out tab.
6. Select a camera that will feed the monitor in the Cameras to Choose from box.
7. Enter a number in the Duration box to set the amount of time (in seconds) that the
video feed is displayed on the monitor. If you select only one camera, the duration is
ignored and the feed is displayed without interruption.
8. Click Add . You have the option of adding more video feeds to the public monitor; to
do so, repeat step 6 to step 8 .
Caution Do not “T-tap” the cable; this can introduce unwanted distortion into the
video signal. To obtain a video feed, use an output port on the Rapid Eye
Hybrid LT DVR.
Using LocalView for Public Display
You have the option of using VGA monitor(s) as a public display monitor. Set LocalView to
display the camera(s) that you need. More than one camera can be displayed
simultaneously. For a better public display of video, and if displaying one video feed at a
time is satisfactory, Honeywell recommends using a dedicated NTSC (or PAL) monitor,
rather than the VGA output used for LocalView.
Connecting a PTZ Dome
Connection to the DVR
Connect the Data In port of a PTZ dome (an RS485 connector) to one of the ports on a
Hybrid LT DVR. Serial ports 3 and 4 do not need a 232/485 converter.