Honeywell Rapid Eye Hybrid LT, Руководство по установке

Страница: 31 / 86

Rapid Eye™ Hybrid LT DVR Installation Guide
Document 800-07766V4 Rev A 31
01/2013
Figure 2-3 Plugging in a Hybrid LT DVR
Powering Up
During the two minutes, or so, that the DVR needs to initialize, it is good practice to NOT
turn it off (see
Unit Recovery , page 33 ).
1. Plug the Rapid Eye Hybrid LT DVR and its cameras into a power source, preferably an
uninterruptible power supply (UPS).
2. Turn on camera(s) and other hardware connected to the DVR.
3. Press the power switch on the back panel of the Hybrid LT DVR. If you have a
LocalView monitor connected (see Monitor on page 35 ) you have the choice of using
the Primary or Recovery system boot (see Booting with Primary or Recovery Operating
System on page 31 ). If no choice is made, the Primary Operating System boot is
selected and executed after 5 seconds.
Note Honeywell recommends that you power the cameras before powering the
Rapid Eye Hybrid LT DVR. This should ensure all the cameras are detected
by the unit when it powers up.
Booting with Primary or Recovery Operating System
Rapid Eye users have two options for booting the operating system. When powering the
unit, users have the option of booting the OS from either the primary or recovery hard
drives. If no selection is made, the primary system boot is selected by default and is
automatically executed after 5 seconds.
SERIAL PORT 2
SERIAL PORT 1 VGA
TELCO
USB USB
LAN
IN
OUT
NOT
USED
1 2 3 4 5 6 7 8
SPOT
MONITOR
VIDEO
INPUTS
C OMMO N
SYS FAIL
SYS GOOD
F AULT
RELAY
28V, 3A
MAX
1 G G G G 2 3 4
CONTROL
OUTPUTS
SERIAL
PORT 3
SERIAL
PORT 4
1 G G G G 2 3 4 5 G G G G 6 7 8
ALARM INPUTS
ON/OFF
POWER
115-230V~
50/60 Hz
5-3A
VIDEO connector on
analog camera to
VIDEO INPUT on DVR
Connect power
supply from camera
to UPS
Connect power supply
from UPS to DVR