LCD6000A
Installing manual
PAGINA - 1
LCD6000A_manu-inst
Doc. M-185.1- LCD6000A-ENG Rev A.1
NOTIFIER ITALIA
N.B.:
Before installing LCD-6000A panel read carefully this manual.
WARNING: This manual refers to all the features available in software revision
indicated on manual’s cover.
DETECTION SYSTEM LIMITS
A security or fire detection system is useful for timely advice of each dangerous event, like fire, theft,
intrusion and in some cases can provide automatic event management (evacuation messages diffusion,
automatic extinguishing systems, CCTV plants interfacing, door and accesses lock, automatic warning of
authorities etc.) but in any case, does not assure protection against property damage or resulting from fire or
theft in general.
Each of these systems needs to be installed carefully in order to work properly.
CAUTION
These instructions contain procedures to follow to avoid devices damages. We assume that
the user of this manual has previously attended a course and knows applicable laws and
regulations.
The system and devices must be installed in an environment with the following
characteristics:
Temperature: -5°C to +40°C
Humidity: 10 % - 93 % (without condensate).
Devices (sensors etc.), not perfectly complying with the control panel can cause damages to
the control panel or system malfunctioning, and this could even happen at the worst time.
That’s why it’s essential to use only material that is indicated by NOTIFIER as compatible
with its control panels. In case of doubt check with NOTIFIER technical assistance.
This system and all its solid state components, can be damaged by induced electrostatic
discharges: handle the boards picking them on borders and avoid to touch electronic
components.
A good grounding connection ensures noise sensitivity reduction
Consult Technical Service NOTIFIER if you are unable to solve installation problems
Any electrical system requires proper power supply. Whether mains is missing, the system
can work with backup batteries, but only for a limited time.
During plant’s programming, consider required autonomy in order to choose the correct
power supply and battery
Periodically check batteries’ level by qualified personnel
Disconnect mains and batteries BEFORE removing or adding any board
Disconnect all power sources, BEFORE performing any service operation
Control panel and connected devices (sensors, modules, annunciators etc.) can be
damaged if a board is inserted or removed, or if cables under voltage are connected.
The most common cause of malfunctioning is bad maintenance
Take care of these issues particularly from the stage of system design, to facilitate and
thereby reduce the future cost of interventions
This device is marked CE, to certify its quality and compliance with European community’s regulations
Electromagnetic Compatibility Directive 89/336/EEC (and 92/23/EEC directive)
Low Voltage Directive 73/23/EEC
National regulations
This device must be installed and operate in compliance with these instructions and
installing place local regulations
Содержание NOTIFIER LCD6000A
Страница 1: ...LCD6000A Remote Panel Installing Manual ...
