- 53 -
3.11 MODE Event set screen
Fig. 3.11.1 MODE EVENT SET
(1)
EVENT No.
Display and Input
z
EVENT No. for setup(21 ~ 40)
z
The EVENT No. display to be set and buttons for input take place on the left. After this
button is pressed, use the keypad on the right pressing the ‘ENT’ key after the input
changes the value and it’s saved, pressing ‘ESC’ key cancels the process.
(2)
Changing EVENT No.
for setup.
(3)
EVENT Content
Display
z
Highlighted according to ‘EVENT No’ configuration in (1) (See below Table).
Table 3.11.1 Mode Event information
ITEM Description
Remarks
STOP
When Program STOP(Quit), ON
READY, END, BREAK,
TROUBLE = ON
RUN
During RUN operating, ON
HOLD, TUNE, WAIT =
ON
READY
READY before operating the program, ON
END
When Program or Fix timer is completed and
the state is END, ON
TRBL
When Trouble status occur, ON
HOLD
When HOLD in process, ON
WAIT
When the state us WAIT, ON
TUNE
In Auto tuning, ON
41
2003.01.23
EXIT
12 H 59 M
MODE
No
MODE EVENT
CH1
ASSIGN to
CONDITION
CH2
(3)
(2)
Return to Configuration
SET screen
(4)
(1)
MODE ASSIGN 3
OR
AND
BOTH
STOP
RUN
READY
END
TRBL
HOLD
WAIT
TUNE
MAN
DOWN
UP
FIX
(5)
(6)
RANGE
OFFSET
MODE
ALARM
( + ) Increase : Whenever this button is pushed, the event No. increases by one.
( - ) Decrease : Whenever this button is pushed, the event No. decreases by one.
