Honeywell Intermec PD43, Руководство пользователя

Страница: 129 / 194

Chapter 5 — Troubleshoot the Printer
PD43 and PD43c Commercial Printer User Manual 115
There are white vertical lines on
the printout. Try these possible solutions in order:
•
The printhead may be dirty. Clean the
printhead.
•
There may be missing dots on the
printhead. Replace the printhead.
•
The ribbon may not be installed
correctly.
Part of a dotted line is missing. Try these possible solutions in order:
•
The printhead may be failing. Replace
the printhead.
•
The strobe signal may be failing. For
help, contact your Intermec service
representative.
The inner edge of the printout is
missing. Try these possible solutions in order:
•
The media may not be properly
installed or aligned. Reload the media.
•
The media margin or X-start
parameter may be set too low. Increase
the setting.
The content on my printout is
compressed. The print speed may be too high. Lower
the print speed.
Nothing shows up on my thermal
transfer printout. The ink-coated side of the ribbon may not
be facing the media. Reload the ribbon.
When I feed or print a label, the
ribbon is not taken up. Instead, it
spills out the front of the printer. Try these possible solutions in order:
•
Make sure the ribbon is loaded
correctly and that you are using the
correct type of ribbon for the printer.
•
If you are using ribbon with a
notchless core, you must use the
ribbon core adapter for the ribbon feed
to work properly.
Problems and Possible Solutions (Continued)
Problem Possible Solution