3
DC1010/1020/1030/1040 PRODUCT MANUAL
3
SET
SET
SET
SET
SET
4.1
Level 1
4.1.1
Press SHIFT key ( ) to change the parameters. If SHIFT key is pressed,
the first digit begins blinking. Press UP key ( ) or DOWN key ( ) to
increase or decrease the value of the digit, then press SHIFT key again to
go to the next digit. As all the digits are written, press SET key to enter
the value.
4.1.2
SET key also has the function of changing MODEs. If SET key is pressed,
the display shows the next MODE.
4.1.3
Press SET key for 5 sec. The display goes to level 2, and do the same thing
to return to level 1.
4.1.4
If any key were not pressed for 1 minute, the display will go to level 1.
4.1.5
Press A/M key to go to level 1, no matter where it is.
4.1.6
If the output percentage is “0”, it means the controller has no output.
PV
SP
Display PV
Display SP
Output
Percentage
Auto Tuning
Status
Alarm 1 Set
Alarm 2 Set
Alarm 3 Set
Press SET key
for 5 sec
