23
6.
Start-up
6.1
Operation with transponders
Hold the transponder approximately
.
Without transponder transmission (5 sec. after the last transmission), the
automatically
switches from active mode to low current mode and thus reduces the current consumption on
average to <11 mA.
If the transponder is used in conjunction with a reader in low current mode, it may take
up to 1.2 sec. until it starts operating. Evaluation takes place within 0.9 sec. when the
read mode is activated.
in the middle of the keypad
In order to achieve a greater transmission range when using the transponder, a relatively high
current is required during transmission (<50 mA).
reader
6.2
Allocate addresses
6.2.1
Introduction
Every reader operated at an AC module bus must have its
address. A
in
the AC system prevents addresses from being allocated several times.
Possible
1 to 32 (address 0 not applicable)
With the ACS-8 from V06.xx upwards, addresses can be allocated in different ways. The following
information is intended to assist you in choosing the best methods for your special requirement. A
detailed description on the individual methods can be found in the following chapters.
With the ACS-8, V05.xx, only the method described under 4.) is possible.
(see 6.2.4)
Enter the unique number (serial number) of the reader plus the desired address via the
programming of the central control unit. The address is then stored in the reader.
(see 6.2.5)
Start the process with a transponder in the reading area of the reader. The address is
allocated automatically and then stored in the reader. As long as the address allocation
mode is active, several readers can be automatically allocated addresses in succession.
Suitable for shorter distances between the AC central control unit and the individual
readers. (Manual input of the unique numbers of the readers is not required).
(see 6.2.6)
An address is allocated via the keypad at the reader.
When a specific address has to be allocated to an reader on site.
(see 6.2.7)
the reader voltage requires connecting at the reader. The address allocation mode
must not be active, neither is a connection to the ACS-8 necessary.
An address is allocated via the keypad at the reader.
When servicing or testing.
: A plausibility check is not possible!
own
plausibility check
address range:
1.) Manually via the central control unit
Recommended standard methods.
2.) Automatically with transponder
Recommendation:
3.) Manually via reader keypad
Recommended:
4.) Manuelly via reader keypad - stand alone operating mode
Only
Recommended:
ATTENTION
Mounting and Operating Instructions - proX2-reader "Accentic" with keypad
5.3
Wiegand interface
F
i
2
3
6
5
4
7
8
9
3
0
r
1
026421.20
red
blue
grey
red/blue
green
Shield
+U_b 12 V DC
0 V
D1
D0
LED green
