2006 ST1300/A
20
©2006 American Honda Motor Co., Inc. - All Rights Reserved
20. Check the oil level (cont.).
If the oil level is below the lower level mark,
remove the right cylinder head over-head
cover and oil filler cap, and add the recom-
mended oil until it is visible in the inspection
window. Replace the oil filler cap.
Start the engine and let it idle for 3 – 5
minutes. Make sure the low oil pressure
indicator goes off. If the indicator remains on,
stop the engine and troubleshoot the cause.
Stop the engine and wait 2 – 3 minutes. Check
the oil level using the above procedure and, if
necessary, add the recommended oil until it
reaches the upper level mark. Do not add oil
above the upper level mark.
•
Oil recommendation: Pro Honda GN4 or
HP4 (without molybdenum additives) 4-
stroke oil or equivalent motor oil
•
Viscosity: SAE 10W-40
•
Classification: SG or higher. Do not use oils
labeled as energy conserving on the circular
API service label.
•
JASO 4T Service Classification: MA
•
Crankcase capacity (after draining): 3.6
Liters (3.8 US Quarts)
Reinstall the oil filler cap and right cylinder
head over-head cover.
21. Check the final drive oil level.
Place the motorcycle on its centerstand on a
firm, level surface.
Remove the oil filler cap and check the oil
level, it should be flush with the lower edge of
the oil filler hole. If the level is low, check for
oil leaks. Add the recommended oil through
the oil filler hole until it reaches the lower
edge of the opening.
Recommended oil: Pro Honda Shaft Drive Oil
or equivalent SAE 80 hypoid gear oil
Reinstall and torque the oil filler cap.
Torque: 12 N·m (1.2 kgf·m, 9 lbf·ft)
FILLER CAP
OIL FILLER CAP
LOWER EDGE
