©2006 American Honda Motor Co., Inc. - All Rights Reserved
7
7. Install the front wheel.
Clean both sides of the front and rear brake
discs with a clean shop towel and Pro Honda
Brake Cleaner or equivalent.
Remove the caliper mounting bolts. Be
careful not to get dust and dirt on the ends of
the mounting bolts.
Support both calipers with a piece of wire,
or similar method, so they do not hang from
the brake hoses. Be careful not to twist the
brake hoses.
Do not operate the brake lever or pedal after
the brake calipers are removed.
Note that the shoulders on each wheel collar
are different sizes. It is important to install
them with the correct sides facing the wheel.
Install the 16.5 mm left-side collar with the
10 mm deep shoulder side facing the wheel.
Install the 27.5 mm right-side collar with the
34 mm outside diameter shoulder facing
the wheel.
Position the front wheel between the
fork legs.
Slide the axle shaft through the left fork leg,
the 16.5 mm left-side collar, front wheel,
27.5 mm right-side collar, and right fork leg.
Push in on the axle shaft so the left end of the
axle shaft is flush with the surface of the left
fork leg.
While holding the axle, install and tighten the
axle bolt to the specified torque.
Torque: 79 N·m (8.1 kgf·m, 58 lbf·ft)
Tighten the right axle pinch bolts to the
specified torque.
Torque: 22 N·m (2.2 kgf·m, 16 lbf·ft)
PARTS
QTY
Front wheel assembly
1
Right front wheel side collar
1
Left front wheel side collar
1
RIGHT SIDE
LEFT SIDE
8 x 45 mm
CALIPER
BOLT
CALIPER
BOLTS
CALIPER
BOLT
AXLE BOLT
PINCH
BOLTS
27.5 mm
RIGHT SIDE
COLLAR
AXLE
SHAFT
16.5 mm
LEFT SIDE
COLLAR
