Note: Make sure the vehicle is in a safe location when using remote engine
start (i.e., a well-ventilated area, away from any flammable materials).
n
Starting the Engine
Press the Lock button, then press and hold the Engine button within 5
seconds to remotely start the engine.
• The engine runs for up to 10 minutes. To extend the run time for another
10 minutes, repeat the procedure during the initial 10 minutes.
• The amber LED blinks, then the green LED comes back on if a 10-minute
extension request was transmitted successfully.
• After pressing the (lock) button, wait for the green LED to blink. This
indicates that the all the doors and the tailgate are locked.
• If you press the button and the transmission is not in P, the vehicle goes
into ACCESSORY mode.
n
Stopping the Engine
Press and hold the Engine button.
When started remotely, the engine shuts off after 10 minutes of idling. It will
also stop if the ENGINE START/STOP button and the brake are pressed
individually.
DRIVING
100 |
Carbon monoxide gas is toxic and can rapidly accumulate in closed or
even partly enclosed areas.
Breathing it can cause unconsciousness and even kill you.
Never use the remote engine starter with the vehicle parked in a garage or
other areas with limited ventilation.
Starting to Drive
Turn on the vehicle and start the engine to begin driving.
n
Before Starting the Engine
Check that the electric parking brake is
applied and the transmission is in P.
Keep your foot firmly on the brake pedal
when starting the engine.
Note: The engine is harder to start in
cold weather and in thinner air found at
altitudes above 8,000 feet (2,400 m).
When starting the engine in cold
weather, turn off all electrical
accessories such as the lights, climate
control system, and rear defogger in
order to reduce battery drain.
n
Changing the Power Mode
*1
Use the ENGINE START/STOP button to cycle through power modes or start
the engine.
*1 - If equipped
DRIVING
| 101
